celestica seastone dx010 100g tor switches transceiver

I then ran the equivalent of sudo config qos reload but rewrote the paths for the new Celestica-DX010 folder since it's going to try to load the Seastone folder by default. Celestica-DX010/2Īnd save your default to 't0' from 't1' for a ToR switch. But likely you're probably using this as a Top of Rack (ToR) switch right near your equipment. Now by default it assumes this is a core switch and has 40m cable lengths. I first copied everything from the Celestica-DX010-C32 to get the QoS and Buffer config files into the vanilla Celestica-DX010 folder (which is empty) and then copied over the Seastone-DX010 config files and overwrote the Celestica-DX010-C32 files where appropriate.Ĭd /usr/share/sonic/device/x86_64-cel_seastone-r0/ So what I did and I'm not sure if this is right to do. But all of the QoS settings are saved in the Celestica-DX010-C32 and the Celestica-DX010 is completely empty. Celestica is the brand and the Seastone is the model. One of the oddities of the Sonic config folder for the Celestica DX010 is that there are separate folders for the Celestica-DX010 and the Seastone-DX010.

So I'm working on trying to get PFC/QoS working on the DX010. That'll get you 90% of the way there on a clean slate to start configuration. Sudo sonic-cfggen -preset l2 -p -H -k Seastone-DX010 -w

Celestica seastone dx010 100g tor switches transceiver